MENSI 2 Packs Flame Sensor Igniter Sensing Rod Fit Replacement of

• Replacement of model 62-24164-01 Flame Sensor Igniter Sensing Rod for Rheem Furnace Include two sets and Replacement for Suburban 232258 2-Prong Electrode Assembly, this is high efficiency spark kit with two sparking for fireplace, fire pit , furnace etc
• DIY Ignition Parts with Double Sparker and 33.5inch 480°F Resistance High Temperature Cable
• Also can be used for any propane or natural igniter system like grill, fire pit and water heater if you can adjust the height of the sparking area to fit your burner
• The electrode pin can be bended if you need adjust the installation size
• This kit need to be worked with igniter or control system to ignition.

This kit of the igniter spark plug with high temperature resistance wire can resist around 480°F temperature during working condition.

• This is normally used in furnace and high power btu and burner system with much more harder pin and ceramic part with higher voltage during spark. And aslo can be a flame sensor, The sensor is a short length of thin metallic rod that creates a small current of electricity in order to confirm there is fire burning within the furnace. As the gas valve opens to begin the combustion process, the current is sent out from the sensor in order to detect the presence of heat from a flame.
• Replacement of 62-24164-01 Flame Sensor Igniter for Reheems Water Heaters Furnace
• Replacement of Suburban 232258 2-Prong Electrode Assembly ( Just electrode part)Totally same
• But it also can be diy fire pit , fireplace or grill , heater etc.
• This can be universal kit if you can adjust the height of spark pin in right posistion. The two pin will increase the power during spark and higher efficiency igniting.
• We also include two piece of small rubber cable piece to gather the wire during using.
• And cable length 31.5"

Install Process: 1.Shut off the power to your furnace (or any other appliance). It is very important. 2.Remove the broken Sensor and replace it with our new sensor. 3.Turn the power back on, Check the Results.

If neccessary, you can make the terminal to be straight by a wrench.

Suitable for RV furnaces, water heaters, indoor and outdoor kitchens, cooktops, ranges and ovens etc.

The cable with terminal fits the electrode terminal and other side with rough 2.3mm terminals

This kit is not only a spark plug electrode kit and also can work with a flame sensor controller by a voltage. you can use it with pulse and piezo ignitions terminal in round.

• Replacement of Suburban 232258 2-Prong Electrode Assembly for Suburban Sw6de Sw10de Water Heater Parts Igniter and Just need Adjust Little on Spark Direction to Fit the Rheem Furnace